TM 5-5420-280-23&P
0032 00
PALLET FRONT AND REAR WHEEL LIFTING CYLINDERS REPLACEMENT (Contd)
INSTALLATION (Contd)
NOTE
Ensure that all mounting hardware is tightened to metric
standards unless otherwise noted. Refer to metric torque limits in
4.
Install wheel lifting cylinders (17) and (22) on slide housing (9) of bridge pallet (8) with eight new
lockwashers (16) and screws (15).
5.
Install elbow (13) on adapter (5) and tighten nut (14).
6.
Install elbow (26) on tee fittings (3) and tighten nut (25).
7.
Install steel tube (30) on tee fitting (3) with new tube seal (2) and tighten nut (31).
8.
Install steel tube (29) on tee fitting (24) with new tube seal (2) and tighten nut (28).
9.
Install steel jumper tube (11) on bottom elbows (13) and (26) with new tube seals (2) and tighten
nuts (12) and (27).
10.
Install steel jumper tube (8) on tee fitting (3) and adapter (5), with new tube seals (2) and tighten
nuts (1) and (10).
11.
Install pallet wheel and tire. Refer to WP 0036 00.
NOTE
The pallet hydraulic system is self-bleeding, and with exception of
the telescopic tube hydraulic cylinders, there is no requirement for
bleeding air from the system.
12.
Operate supporting cylinders and check for leaks. Refer to TM 5-5420-280-10.
13.
Lift pallet wheel supporting cylinder to stowed position. Refer to TM 5-5420-280-10.
11
10
2
7
5
6
8
9
15
4
2
6
~
16
5
3
12
1
2
14
13
16
31
15
6
30
5
17
29
22
18
28
2
27
6
19
21
20
24 23 5
2
26
25
END OF WORK PACKAGE
0032 00-3/4 blank