TM 5-5420-280-23&P
0088 00
LOWER SUPPORT ROLLER ASSEMBLY REPLACEMENT (Contd)
INSTALLATION (Contd)
5.
Remove lifting device and chain or sling.
NOTE
Install hoses as noted at removal.
6.
Connect two hoses (13) to pin wheel drive hydraulic motor (12).
7.
Connect hoses (16) and (20) on adapter (15) and elbow (18) of stop cylinder (14) and tighten hex
nuts (17) and (19).
NOTE
The pallet hydraulic system is self-bleeding, and with exception of
the telescopic tube hydraulic cylinders, there is no requirement for
bleeding air from the system.
8.
Start LPU, depress KY1 and KY19 control valves simultaneously to raise launch boom (10) to
+90-degrees position. Install retaining pins on launch boom.
1
12
13
14
18
10
19
15
10
20
17
16
END OF WORK PACKAGE
0088 00-5/6 blank