TM 55-1945-205-10-2
0016 00 1
0016 00
OPERATOR MAINTENANCE
ROLL-ON/ROLL-OFF DISCHARGE FACILITY
MOORING BITTS AND QUICK DISCONNECTS
OPERATION UNDER USUAL CONDITIONS
INITIAL SETUP:
Tools
Tool Kit, General Mechanic’s (Rail and Marine) (Item 7, WP 0121 00)
Life Preserver, Vest (Item 33, WP 0119 00)
Gloves, Men’s and Women’s (Leather Palm) (Item 25, WP 0119 00)
Goggles, Sun, Wind and Dust (safety) (Item 27, WP 0119 00)
Helmet, Safety (Item 29, WP 0119 00)
Crowbar (Item 16, WP 0119 00)
Hammer, Hand (10 lb Sledge) (Item 29, WP 0119 00)
Forklift Fork Extenders (Item 21, WP 0119 00)
Push Rod (Item 45, WP 0119 00)
Chain, ½ in. General Purpose (Item 14, WP 0119 00)
5300 lb 4 ft Sling (Green) (Item 50, WP 0119 00)
Personnel Required
Seaman 88K
PREPARATION FOR USE - INSTALLATION OF MOORING BITTS AND QUICK DISCONNECTS
REMOVE MOORING BITTS FROM ISO CONTAINER
:,1*
All personnel must wear personal flotation device, hard hat, safety shoes and gloves
during RRDF operations and maintenance. Failure to observe these precautions
could result in serious injury or death.
1.
Remove straps securing mooring bitt pallets to ISO container.
:,1*
2.
Using forklift and fork extenders, remove first stack of pallets from ISO container.
3.
Remove one fork extender from forklift and install push-pull rod.
