TM 55-1945-205-24-4
0105 00 6
0105 00
WARNING
CAUTION
Care must be exercised when handling coil. Failure to comply could result in
damage to equipment.
6.
Position coil (16) on base pan (24).
7.
Install two screws (23) in base pan (24) and tighten screws (23).
8.
Connect fan motor wires (20) to capacitor (21) and switch (22).
9.
Close hinged cover (19) upward.
10. Install two screws (17) in the front control box (18) and tighten screws (17).
11. Position condenser cover (14) on coil (16).
12. Install condenser cover tabs (15) on coil (16).
13. Position gusset (13) on condenser cover (14).
14. Install screw (12) in gusset (13) and tighten screw (12).
15. Install two screws (11) in partition (10) and tighten screws (11).
16. Position fan motor ground wire (9) on partition (10).
17. Install screw (8) in fan motor ground wire (9) and tighten screw (8).
18. Install heating and air conditioning system discharge deck. (WP 0101 00)
19. Position top cover (7) on chassis (3).
20. Install screw (6) in top cover (7) and tighten screw (6).
21. Position top panel (5) on chassis (3).
22. Install two screws (4) in top panel (5) and tighten screws (4).
23. Position air discharge grille (2) on chassis (3).
24. Install two screws (1) in air discharge grille (2) and tighten screws (1).
25. Install heating and air conditioning system front cover. (WP 0096 00)
26. Perform operational check of heating and air conditioning system fan motor. (TM 55-1945-205-10-4)
END OF WORK PACKAGE
