TM 11-2019 Test Sets I-49, I-49-A, and I-49-B
that will satisfy the required unite of measure will be
requisitioned.
and ZM-4B/U.
e. Quantity Incorporated in Unit. This column in-
dicates the quantity of the item used in the equip-
1-5. Location of
Repair Parts
ment. Subsequent appearance of the same item in
a. This manual contains one cross-reference index
the same assembly are indicated by the letters
(see IV) to be used to locate a repair part when
"REF".
either the Federal stock number or reference number
f. 30-Day DS/GS Maintenance Allowances.
(manufacturer's part number) is known. The first
column in the index is prepared in numerical or
NOTE
alphanumeric sequence in ascending order. The
reference numbers" (manufacturer's part numbers)
Allowances in GS column are for GS main-
are listed immediately following the last listed
tenance only.
Federal stock number in the index of Federal stock
numbers.
(1) The repair parts indicated by asterisk entries
b. When the Federal stock number or reference
in separate allowance columns for DS and GS
number is known, follow the procedures given in (1)
represent those authorized for use at that category of
and (2) below.
maintenance to be requisitioned on an "as required"
(1) Refer to the index of Federal stock numbers
basis, until stockage is based on demand in ac-
(see IV) and locate the Federal stock number or
cordance with AR 710-2.
reference number. The FSN and reference number
(2) Allowance quantities are indicated in the
are cros-referenced to the applicable figure and
special tool lists section for special 'tools, TMDE,
item number or reference designation.
and other support equipment.
g. 1- Year Allowances Per 100 Equip-
(2) Refer to the repair parts list (see 11) and
locate the figure number (Col -10a) and item number
ments/Contingency Planning Purposes. Column in-
or reference designation (Col 10b) and item number
tentionally left blank.
or reference designation (Col 10b) as noted in the
h Depot Maintenance Allowance Per 100 Equip.
FSN index.
ments. This column indicates opposite the first ap-
c. When the figure and item number or reference
pearance of each item the total quantity authorized
designation are known, scrutinize columns 10a and
for depot maintenance of 100 equipments.
10b of the repair parts list (see 11) until the item is
i. Illustration. This column is divided as follows:
located.
(1) Figure number. Indicates the figure number
d. When the FSN, reference number, figure num-
of the illustration on which the item is shown in TM
11-2019.
ber, item number and reference designation are not
(2) Item number. Indicates the item number or
known, scrutinize column 3 of the repair parts list
reference designation used to reference the item in
(see II), which is arranged in alphabetical order.
the illustration.
Not applicable.
a. Usable on codes are included in column 3. Un-
coded items are applicable to all models. Iden-
1-7. Reporting of
Equipment Publication
tification of the usable on codes used in this
publication are-
Improvements
The reporting of errors, omissions, and recom-
Code
Used on
mendations for improving this publication by the in-
AFV
ZM-4A/U
dividual user is encouraged. Reports should be sub-
AFW
ZM-4B/U
mitted on DA Form 2028 (Recommended Changes to
ZM-4B/u
A9F
Publications) and forwarded direct to Commander,
b. The following publication pertains to the equip-
US Army Electronics Command, ATTN: AMSEL-
ment and its components:
MA-CRA, Fort Monmouth, NJ, 07703.
(Next printed page is 6)