• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
ALTERNATOR REPAIR INSTRUCTIONS (Continued) - TM-5-1940-277-34_109
ALTERNATOR REPAIR INSTRUCTIONS (Continued) - TM-5-1940-277-34_111

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
  88    89    90    91    92  93  94    95    96    97    98  
TM 5-1940-277-34 ALTERNATOR REPAIR INSTRUCTIONS (Continued) LOCATION ITEM ACTION REMARKS 16. Slip ring end a. O-ring a. Fit into shield (26) and inside bearing stator (20) housing (28). assembly b. Smear light coat of grease on inside of ring. b. Rotor (19) a. Support as Be very careful and drive shown on not to damage end shield figure and slip rings and assembly (18) insert rotor windings. shaft through stator into bearing housing (28) so that slip ring bearing (33) enters bearing housing. b. Press end shield up to stator as far as possible by hand. c. 3 through- a. Fit lockwashers screws (16) to each screw. and 3 lock- washers (17) b. Coat screw threads with loctite. c. Insert screws through end shield. 2-79







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.