• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
ALTERNATOR REPAIR INSTRUCTIONS (Continued) - TM-5-1940-277-34_107
ALTERNATOR REPAIR INSTRUCTIONS (Continued) - TM-5-1940-277-34_109

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
  86    87    88    89    90  91  92    93    94    95    96  
TM 5-1940-277-34 ALTERNATOR REPAIR INSTRUCTIONS (Continued) LOCATION ITEM ACTION REMARKS 13. Drive end a. Bearing (32) Press into Make sure bearing shield (18) housing. is square to housing. b. Clamping Position on end plate (31) shield. c. 3 screws (29) Screw in and Use flat tip and 3 lock- secure plate. screwdriver. washers (30) 14. Stator (20) a. Stator (20) Place on bench with 3 leads up. b. Slip ring Lower end shield Make sure three end shield onto stator. leads pass (26) through three wide gaps in heat sink. c. Stator leads a. Insert end (27) in tag. b. Solder. Use soldering iron. 15. Drive end a. Drive end Support on Surface should shield (18) shield (18) suitable have hole to surface. admit rotor shaft. b. Rotor (19) a. Fit bearing spacer. b. Press rotor Be careful not to shaft into damage slip ring, bearing (32) slip ring ter- in drive end minals or field shield (18). coil leads. 2-77







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.