• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
ENGINE WIRING HARNESS REPLACEMENT INSTRUCTIONS (Continued) - TM-5-1940-277-34_126
ENGINE WIRING HARNESS REPLACEMENT INSTRUCTIONS (Continued) - TM-5-1940-277-34_128

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
  105    106    107    108    109  110  111    112    113    114    115  
TM 5-1940-277-34 ENGINE WIRING HARNESS REPLACEMENT INSTRUCTIONS (Continued) LOCATION ITEM ACTION REMARKS c. Three small Disconnect. Use 1/2 in leads to R- socket.  Leave (negative) heavy inter- terminal engine battery and battery cables connected. d. Two small Disconnect. Use 1/2 in leads to B+ socket.  Leave (positive) heavy battery terminal cable connected. 3. Control box (8) a. Starter Disconnect two Use 11 mm socket solenoid leads by remov- on one large leads (9) ing two nuts nut.  Use 8 mm and washers. socket on smaller nut. b. Thermostart Disconnect leads Use 11 mm socket solenoid by removing four on two larger leads (10) nuts and washers. nuts.  Use 8 mm socket on smaller nuts. c. Capacitor Disconnect two Use 7/16 in open leads (11) places by remov- end wrench.  One ing one nut and connection on washer each bottom of regula- location. tor box, one on side. d. Nut (12) Unscrew and Use 1-5/8 in leave loose on wrench. cable. 2-97







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.