• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
ENGINE WIRING HARNESS REPLACEMENT INSTRUCTIONS (Continued) - TM-5-1940-277-34_130
ENGINE WIRING HARNESS REPLACEMENT INSTRUCTIONS (Continued) - TM-5-1940-277-34_132

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
  109    110    111    112    113  114  115    116    117    118    119  
TM 5-1940-277-34 ENGINE WIRING HARNESS REPLACEMENT INSTRUCTIONS (Continued) LOCATION ITEM ACTION REMARKS 4. Wiring harness Nut (12) Remove from cable cable (15) by sliding off toward end that connected to engine. INSTALLATION: 5. Wiring harness Nut (12) Slide on cable Slide on cable cable (15) from engine all the way to connection end. plug end. 6. Control box (8) a. Wiring Slide end of Use both hands. Harness cable that con- Work cable in cable (15) nects to engine short moves. (one without Slide through plug) through until about 1-1/2 large hole in inches of heavy bottom of con- rubber cable trol box.Go is left in from inside control box. control box toward outside. b. Fitting (16) Slide fitting, Fit through hole removed in threads first, in control box step 3h over cable until threads are starting from visible inside engine connec- box. tion end until it seats in hole in control box. c. Nut (12) Screw on fit- Make sure all ting (16). wires pass through nut. 2-101







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.