• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
ENGINE WIRING HARNESS REPLACEMENT INSTRUCTIONS (Continued) - TM-5-1940-277-34_132
ENGINE WIRING HARNESS REPLACEMENT INSTRUCTIONS (Continued) - TM-5-1940-277-34_134

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
  111    112    113    114    115  116  117    118    119    120    121  
TM 5-1940-277-34 ENGINE WIRING HARNESS REPLACEMENT INSTRUCTIONS (Continued) LOCATION ITEM ACTION REMARKS NOTE Before starting any connecting, look at the diagrams made when cable was removed.  Use wiring diagram and wire reference index.  If there is a question check wiring on other engine as guide. d. Capacitor Connect leads Make sure all leads (11) and install wires pass washer and nut through nut. each location. e. Thermostart Connect leads solenoid and install leads (10) washer and nut each of four locations. f. Starter Connect leads solenoid and install leads (9) washer and nut each of two locations. g. Receptacle Position recep- securing tacle and secure screws (14) by installing four screws and nuts. NOTE Refer to notes taken on cable routing before removal.  Use as guide to help properly route new cable. 2-103







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.