• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
HYDROJET ASSEMBLY REPLACEMENT INSTRUCTIONS (Continued) - TM-5-1940-277-34_374
HYDROJET ASSEMBLY REPLACEMENT INSTRUCTIONS (Continued) - TM-5-1940-277-34_376

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
  353    354    355    356    357  358  359    360    361    362    363  
TM 5-1940-277-34 TM 1940-34/3 HYDROJET ASSEMBLY REPLACEMENT INSTRUCTIONS (Continued) LOCATION ITEM ACTION REMARKS INSTALLATION NOTE If assembly has rear reaction case attached, it must be removed.  To remove case, remove eight cap screws, nuts and washers and then remove case.  Case may be attached to steering assembly. Refer to steering assembly removal procedure. 6. Hydrojet Intake gasket Coat one side of Item 12, APP. B. Compartment (19) gasket with Make sure bolt rubber base holes are adhesive and alined. stick into posi- tion on hull interior. 7. Hydrojet Sling Attach to intake assembly case and to lifting device. 8. Hydrojet Hydrojet Carefully lift Use drift pins compartment assembly assembly and through corner position into bolt holes to compartment, assist in aline- alining bolt ment.  Be careful holes. not to displace the intake gasket (19) and to aline bolt holes as unit is posi- tioned. NOTE Before going to next step look at diagram.  Note order in which mounting bolts are installed. Change 4   2-361







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.