• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
HYDROJET ASSEMBLY REPLACEMENT INSTRUCTIONS (Continued) - TM-5-1940-277-34_370
HYDROJET ASSEMBLY REPLACEMENT INSTRUCTIONS (Continued) - TM-5-1940-277-34_372

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
  349    350    351    352    353  354  355    356    357    358    359  
TM 5-1940-277-34 HYDROJET ASSEMBLY REPLACEMENT INSTRUCTIONS (Continued) LOCATION ITEM ACTION REMARKS WARNING Exercise care in removing intake grille.It  weighs  30  pounds  and  retainer  may  separate  from  grille when mounting bolts are removed. Injury to personnel will result. NOTE Before   next   step,   check   bolt   installation   diagram   for   four   unmarked   bolts.      These   are   bolts removed in next step. 3. Hull, aft 4 nuts (9), Remove nuts, Three persons underside 4 washers (10), washers and required, one and 4 socket bolts. When inboard, two head bolts (11) last bolt is outboard. Use securing intake removed grille 3/8 in hex key grille will drop free. wrench (Allen) outboard and 14 mm socket, ratchet and extension in- board. 4. Hydrojet intake a. 2 cap screws Remove from Use 19 mm socket case (14) (12) and 2 underneath boat. and ratchet. washers (13) securing aft end of intake case 2-357







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.