• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
ENGINE BLOCK INSPECTION AND REPLACEMENT INSTRUCTIONS (cont) - TM-5-1940-277-34_519
ENGINE BLOCK INSPECTION AND REPLACEMENT INSTRUCTIONS (cont) - TM-5-1940-277-34_521

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
  498    499    500    501    502  503  504    505    506    507    508  
TM 5-1940-277-34 ENGINE BLOCK INSPECTION AND REPLACEMENT INSTRUCTIONS (Continued) LOCATION ITEM ACTION REMARKS NOTE The cylinder block assembly consists of the cast cylinder block with the integrally cast upper half of the crankcase and the seven main bearing caps. INSPECTION AND REPLACEMENT Cylinder block (1) a. Cylinder a. Pressure test block (1) for cracks as follows: * Fit new head gasket (2). * Install 1/2 Head gasket can in thick be used as pat- steel plate tern for boring on top of bolt holes. cylinder block (1). * Install 25 Use torque bolts with wrench (0 - 175 washers to ft-lb cap.) secure steel with 3/4 in soc- plate, ket. torque bolts to 135 ft-lb. * Install Use 1/2 in socket suitable with torque cover with wrench (0- 175 air hose con- ft-lb). nection and new gasket over water pump hole (3) in front face of block. Secure cover using four 5/16 in UNC bolts. Torque to 15 ft-lb. * Attach air hose to water pump hole cover. 3-89







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.