TM 5-1940-277-34
TRANSMISSION REPAIR INSTRUCTIONS
(Continued)
LOCATION
ITEM
ACTION
REMARKS
d.
Assembly can
be completed
using hand
pressure until
piston bottoms
in adapter (1).
43.
Transmission case
a.
Adapter
a.
Coat with
Aline all holes.
(47)
gasket (4)
petroleum
jelly.
b.
Position on
exposed front
face of case.
b.
Forward and
a.
Fit squarely
The plug in adap-
reverse
over input
ter is at top of
adapter (1)
shaft and
adapter. This
lower as far
alines with top
it will go.
of transmission.
Shoulder on rear
of adapter should
b.
Aline oil
enter mating bore
holes in adap-
in reverse clutch
ter with those cavity.
in case.
NOTE
Before proceeding to next step check gap between adapter and case at several points to insure
that adapter is squarely in place.
44.
Adapter (1)
4 cap screws (2)
a.
Install and
Tighten the bolts
tighten finger
in an X pattern
tight. Alter-
to insure proper
nately tighten
draw down.
each cap screw
1/2 turn at a
time to draw
adapter into
place.
3-161