• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
HYDROJET ASSEMBLY REPAIR INSTRUCTIONS-TWO STAGE DRIVE SECTION (cont) - TM-5-1940-277-34_626
HYDROJET ASSEMBLY REPAIR INSTRUCTIONS-TWO STAGE DRIVE SECTION (cont) - TM-5-1940-277-34_628

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
  605    606    607    608    609  610  611    612    613    614    615  
TM 5-1940-277-34 HYDROJET ASSEMBLY REPAIR INSTRUCTIONS-TWO STAGE DRIVE SECTION (Continued) LOCATION ITEM ACTION REMARKS b.  Grease lightly to hold. c.  Reverse a.  Fit over shaft thrust on outside of bearing (20) needle bearing. b.  Grease lightly to hold in position. 24.   Bearing cap (9) a.  Seal (17) Fit into cap. Use new seal Position lip toward open face of cap. b.  Gasket (18) a.  Lightly grease and stick to cap. b.  Aline bolt holes. 25. Drive flange (7) a.  Seal sleeve Slide on flange. (16) b.  Bearing cap Slide over seal (9) sleeve on flange. c.  Spacer (15) Slide on flange. d.  Thrust Fit into bearing washer (14) cap. e.  Thrust a.  Fit into bearing (13) bearing cap. 3-199







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.