• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
HYDROJET ASSEMBLY REPAIR INSTRUCTIONS-TWO STAGE DRIVE SECTION (cont) - TM-5-1940-277-34_628
APPENDIX A REFERENCES - TM-5-1940-277-34_630

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
  607    608    609    610    611  612  613    614    615    616    617  
TM 5-1940-277-34 HYDROJET ASSEMBLY REPAIR INSTRUCTIONS-TWO STAGE DRIVE SECTION (Continued) LOCATION ITEM ACTION REMARKS b.  Grease to hold in position. f.  Main thrust Fit into bearing washer (12) cap. 26. Hydrojet a.  Key (19) Fit into groove assembly on shaft. shaft (2) b.  Bearing Slide on shaft. Assembly includes cap (9) drive flange. subassembly 27. Bearing cap (9) 8 washers (11) Install. When installing and 8 socket cap make sure oil head screws (10) connection is straight up. 28. Hydrojet a.  Drive flange Slide over shaft assembly cone (8) and key. shaft (2) b.  Washer (6) a.  Put nonhar- Flange side of and main dening loc- washer goes shaft nut (5) tite on toward cone (18). threads and install washer and nut. b.  Tighten to 150 ft-lb. 29. Bearing cap (9) Washer (3) and Install in cap (9). plug (4) 3-201 (3-202 Blank)







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.