Replacement Engine Installation (Sheet 3 of 17)
Using 1-5/8 inch wrench to hold adapters
(L), use 1-1/2 inch wrench to remove two
nuts (M) from two adapters (L).
Remove oil cooler tube assemblies (G) and (K).
Using screwdriver, remove clamps (N)
Remove engine breather tube (Q) from
adapter (R) from engine.
Using 7/16 inch wrench to hold screw
(S), use 7/16 inch wrench to remove nut
(T). Remove linkage (U) from
accelerator cross shaft (V).
Use procedure described in step 11 and
remove linkage (W).
Go on to Sheet 4