• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
DISASSEMBLY-continued - TM-5-5420-202-340241
DISASSEMBLY-continued - TM-5-5420-202-340243

TM-5-5420-202-34 M60A1 Tank Chassis Transporting: for Bridge Armored-Vehicle-Launched; Scissoring Type Class 60 (5420-00-889-2020) Manual
Page Navigation
  210    211    212    213    214  215  216    217    218    219    220  
TM 5-5420-202-34
FINAL DRIVE REPAIR (Sheet 16 of 30)
78.
Install three short pins (3-1/2 inches
long) and washers into holes marked "B"
in bearing remover tool.
Check that three pins match holes in
79.
output shaft (AJ).
Position bearing remover tool above
80.
output shaft (AJ) assembly with pins
through matching holes in flange (AM)
of output shaft (AJ) assembly.
Using two people, support output shaft
81.
(AJ) and position bearing remover tool
and output shaft (AJ) under arbor press.
Using arbor press, apply pressure to
82.
center of bearing remover tool until
remover touches face of output shaft (AJ).
Release arbor press pressure and
83.
remove bearing remover tool from
output shaft (AJ).
Remove short pins from bearing
84.
remover tool and replace with 5 inch
pins.
Go on to Sheet 17
Change 2
7-16






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.