• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
ASSEMBLY - TM-5-5420-202-340244
ASSEMBLY-continued - TM-5-5420-202-340246

TM-5-5420-202-34 M60A1 Tank Chassis Transporting: for Bridge Armored-Vehicle-Launched; Scissoring Type Class 60 (5420-00-889-2020) Manual
Page Navigation
  213    214    215    216    217  218  219    220    221    222    223  
TM 5-5420-202-34
FINAL DRIVE REPAIR (Sheet 19 of 30)
Apply oil to preformed packing (D) and
4.
install on special tool oil seal replacer
(E).
5.
Install oil seal replacer (E) over splined
end of shaft (A) with preformed packing
end down. Push replacer down to bearing
surface of shaft.
6.
Roll preformed packing (D) off replacer
(E) and on shaft (A).
7.
With replacer (E) in same position,
carefully press preformed packing (D) into
recessed area between spacer (C) and
shaft (A). Seat preformed packing (D)
flush or below top edge of spacer (C).
Remover replacer (E) from shaft (A).
8.
9.
Using clean, lint-free rag, wipe both inner
and outer parts of seals (F) and (G) to
remove any foreign material. Apply oil to
surfaces of seals (F) and (G).
10.
Apply oil to o-ring (H). Install o-ring (H)
on spring seal (G).
11.
Install spring seal (G) in cap (J) with four
pins thru four holes in cap (J).
Place seal (F) over output shaft (A).
12.
Aline seal (F) hole with output shaft (A)
pin and press down to engage spacer(C).
13.
Install eight bolts (K) in ring (L).
14.
Using two persons, lift ring (L) and
position on output shaft (A).
With cap (J) seal side facing spacer (C),
15.
place cap (J) over spacer (C) with eight
bolts (K) thru eight holes of cap (J).
16.
Grasp cap (J) and press down firmly. Cap
(J) will spring back when properly
installed.
Go on to Sheet 20
7-19
Change 2






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.