• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
ASSEMBLY - TM-5-5420-202-340348
CHAPTER 13. PRE-EMBARKATION INSPECTION

TM-5-5420-202-34 M60A1 Tank Chassis Transporting: for Bridge Armored-Vehicle-Launched; Scissoring Type Class 60 (5420-00-889-2020) Manual
Page Navigation
  313    314    315    316    317  318  319    320    321    322    323  
TM 5-5420-202-34
GRENADE LAUNCHER CONTROL POWER BOX REPAIR (Sheet 7 of 7)
Put flat washer (P) on switch (Q).
16.
17.
Put key washer (R) on switch (Q).
with key tab facing out.
18.
Put packing (S) on switch (Q).
19.
Place switch (Q) through hole in cover (H) with key tab aligned with keyway of cover.
20.
Put switch guard (T) and lockwasher (U) on switch (Q).
21.
Using wrench, put nut (V) on switch (Q) and tighten nut (V).
22.
Put 1/2" long piece of insulation sleeving over each wire (W).
23.
Using soldering iron and solder, solder tagged wires (W) to terminals of switch (Q).
Remove tags from wires.
24.
Put insulation sleeving over soldered connections of switch (Q).
25.
Using heat gun, shrink insulation sleeving.
26.
Slide new gasket (X) over cover
(H).
27.
Carefully place gasket (X) and
cover (H) on case (D) while pushing
wires (L) and (W) inside case (D).
28.
Using screwdriver, attach cover
(H) to case (D) with four lockwashers
(Y) and four screws (Z).
End of Task
12-7/(12-8 blank)






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.