TM 5-5420-226-20-2
RIGHT EXHAUST EJECTOR TUBE REPLACEMENT (Sheet 3 of 4)
INSTALLATION:
Position insulation (A and B) to ejector
tube (C).
Using cross-tip screwdriver and 5/1 6 inch
wrench, install 11 screws (D), 22 flat
11 nuts (G) to secure insulation (A and B)
to ejector tube (C).
Position packing (H) and clamp (J) OntO
ejector tube (C). Use flat-tip screwdriver
to tighten clamp (J).
Apply coating of silicone compound
4.
to end of hose (K).
Position right exhaust ejector tube (C)
5.
and new gasket (L) onto studs of turbo-
supercharger (M) and hose (K).
Using 9/16 inch wrench, install six new
6.
self-locking nuts (N) to secure right ex-
haust ejector tube (C) to turbosuper-
charger (M).
ENGINE RIGHT BANK
Go on to Sheet 4
8-27