• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Safety Wiring Procedures (Sheet 1 of 2)
Single Fastener Double-Twist Safety Wiring

Launcher Hydraulics System M48A5/M60A1 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 Page Navigation
  686    687    688    689    690  691  692    693    694    695    696  
TM 5-5420-228-24
GENERAL MAINTENANCE - Continued
Safety Wiring Procedures (Sheet 2 of 2)
NOTE
Always use new lockwire.
NOTE
Drilled head bolts and screws installed with self-locking nuts
or lockwashers usually do not require safety wiring.
NOTE
Do not use lockwire to secure fasteners or fittings together that
are spaced more than 6 inches apart.
NOTE
Use care when installing lockwire to be sure it is tight but not over-
stressed.
NOTE
When safety wiring castellated nuts on drilled studs, tighten
nut to low side of torque range (unless otherwise specified)
and continue tightening until a slot alines with hole.
NOTE
Safety wire drain plugs and cocks to adjacent (less than 6
inches away) bolts, nuts, or parts having a free lockhole.
NOTE
S a f e t y wire electrical connectors which have threaded
coupling rings or plugs which have screws to fasten the
individual parts of the plug together. Safety wire connectors
and plugs individually.
End of Task
C-29






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.