TM-5-5420-279-10
3.5.1.14
Replace the R clips from the front mudguard-securing peg back into the mudguard ready
for use on mudguard refit.
3.5.1.15
Replace the R clips from the rear mudguard shootbolt on the vehicle, back into the
shootbolt ready for use on mudguard refit.
Position of Mudguard R clips
3.5.1.16
Deploy the tail lift and the far bank support as described in Section 3.2.1, Paragraphs
3.5.1.17
Remove A-frame leg hinge pins and clips, 2 on the left hand side and 2 on the right hand
side.
3.5.1.18
Press the A-frame fold DEPLOY button only when the A-frame hinge pins have been
removed.
3.5.1.19
Make sure the outer-leg-folding hydraulic cylinders extend and pivot both outer A-frame
legs outwards about the upper and lower A-frame transverse beams to their deployed
positions.
3.5.1.20
Ensure that the A-frame deployed lamp illuminates and that the A-frame parked lamp
extinguishes.
3.5.1.21
Release the DEPLOY pushbutton when the outer A-frame legs are fully spread.
3.5.1.22
Install the locking pins and their R clips in the outer A-frame legs at the upper and lower
transverse beam hinge points to lock the legs in the spread position. Long pins are
inserted into the lower beam from the front to rear. The short pins are inserted in the
upper beam from the front to rear.
3-40