TM-5-5420-279-10
CAUTION
Do not engage the launch vehicle transmission, and drive it forward or backward, in excess of
2 mph (3.2 kph), the A-frame could be damaged.
3.5.2.2
Select a forward gear and slowly (not exceeding 2 mph (3.2 kph)) drive the vehicle
forward to fully extend the slide frame.
3.5.2.3
When in position select neutral on the transmission and ensure that the handbrake is
properly applied.
3.5.2.4
Set the 4-position mode selector rotary switch to position 2. Make sure the PTO engages
and the engine rpm goes to high idle.
3.5.2.5
If the engine does not go to high idle or the PTO pump does not engage then check that
The following lights should be illuminated:
E Stop Reset
On Bridge Build Select
Reset
Launcher Deploy
On Supplies Status
Vehicle Supply
PTO Engaged at Pressure
Controller
5 second delay
Neutral Lock Up
comes on
Crane
Bridge Deployment
PTO Engaged at pressure
2 second delay
Tail lift
Fast Idle
after Neutral Lock
Up comes on
Launcher Deployment
2 second delay
On Vehicle Status (at the top of panel)
Tail lift Supply
after Fast Idle
comes on
Neutral Selected
Brake Applied
Launcher Deployment
On Vehicle Status
On Launcher Deployment Controls
Neutral Applied
A-frame Fold
Brake Applied
Parked
On Controller Status
A-Frame Rotate
Launcher Control Healthy
Launcher Down
3-44