TM 5-1940-277-34
ENGINE ASSEMBLY TEST INSTRUCTIONS (Continued)
LOCATION
ITEM
ACTION
REMARKS
1.
Cylinder head
Compression gage
a.
Install injec-
(1)
tor seal
washer (14).
b.
Position gage
in injector
mounting hole.
NOTE
Compression gage crosshead must be positioned so that gage does not bottom out when fit in mounting
hole.
2.
Compression gage
Injector moun-
a.
Install two
(1)
ting bolt (16)
bolts through
gage crosshead
(3). Tighten
bolts finger
tight.
b.
Screw gage
into crosshead
until gage
stem bottoms
against injec-
tor seat.
c.
Torque injec-
tor mounting
bolts (16) to
14 to 16 ft-lbs
(19.0 to 31.7
Nm).
d.
Turn gage
Use fingers.
pressure re-
lease screw
(2) clockwise
until closed.
Change 1 2-175