TM 5-1940-277-34 ENGINE ASSEMBLY REPLACEMENT INSTRUCTIONS (Continued) LOCATION ITEM ACTION REMARKS LOCATION ITEM ACTION REMARKS d.  Transmission Transfer to See page 2-345 (17.1) replacement for procedure. engine. 17.  Replacement a.  Engine assembly a.  Attach engine (32) sling to assembly (32) lifting eyes (42). b.  Lift engine Use lifting into boat, device. position on mounts (33). b.  Keel cooler Connect inlet Use screwdriver. hoses (41) and outlet (MK2) pipes (40) and tighten hose damps. c.  4bolts(20) Install and Use 11/16in and 4 nuts (21) tighten, open end wrench securing trans- and 11/16 in box mission to wrench. drive shaft. d.  4 nuts (34) and Torque to 30-35 Use torque 4 washers (35) ft-lb (4.15 to wrench (0-175 4.84 kg m) ft-lb). securing engine to mounts. e.  Wiring loom to Secure connec- See page 2-87 engine and tors to contact for procedures. screened points. alternator loom f.  Exhaust bellows Connect to Use 1/2 in box (25) (MK1 ) exhaust pipe wrench. (24) and tighten hose damp. Change 7 2-187