TM 5-1940-277-34 TURBOCHARGER REPAIR INSTRUCTIONS (Continued) LOCATION ITEM ACTION REMARKS 15. Insert (15) a. O-ring (17) Fit on insert. b. Spacer Push into insert sleeve (16) from housing side. 16. Bearing housing Insert (15) Insert into Do not disturb (24) housing. O-ring (17). 17. Turbine wheel a. Snap ring Install. Use snap ring and shaft (22) (14) pliers. b. Compressor Mount on shaft, Use 1/2" box wheel (13) secure with wrench. nut (12). 18. Center core Oil drain tube Install. Use 1-1/4" box assembly (3) (10) and nut (11) wrench. 19. Turbine housing a. Inlet flange Clean gasket Use wire brush (4) (27) face. or putty knife. b. "V" clamp (8) Aline with housing using scribe marks. c. Center core Aline with assembly (3) housing using scribe marks. d. "V" clamp (8) Tighten lock nut Use 7/16" open (9) to secure end wrench. core to housing. 20. Center core a. Compressor Aline scribe assembly (3) housing (2) marks. 2-243