TM 5-1940-277-34 INJECTION PUMP REPLACEMENT INSTRUCTIONS (Continued) LOCATION ITEM ACTION REMARKS 1. Injection pump (1) a. Stop control Remove two Use screwdriver. cable clamp screws and (2) clamp. b. Stop control Loosen screw Use 11/32 in cable holding and pull stop wrench. screw (3) control cable free. c. Throttle Remove two Use screwdriver. cable retain- screws and ing clamp (4) bracket. d. Throttle Pull out pin Use long nose cable cotter and move cable pliers. pin (5) aside. e. 6 injector Unscrew. Use 5/8 in open pipe union end wrench. nuts (6) f. Fuel line Unscrew one nut Use 1/2 in open union nut (7) at injection end wrench. pump end and one Remove line. nut at fuel fil- ter end of line. g. Governor Unscrew one nut Use 1/2 in open vacuum line at governor and end wrench. nut (17) loosen one nut on intake mani- fold end. h. Oil line (18) Loosen nut (19) Use 3/4 in wrench and disconnect oil line(18). 2-247