INJECTION PUMP REPLACEMENT INSTRUCTIONS (Continued)

INJECTION PUMP REPLACEMENT INSTRUCTIONS (Continued) - TM-5-1940-277-34_279

INJECTION PUMP REPLACEMENT INSTRUCTIONS (Continued) - TM-5-1940-277-34_281

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
263

TM 5-1940-277-34 INJECTION PUMP REPLACEMENT INSTRUCTIONS (Continued) LOCATION ITEM ACTION REMARKS h. Stop control Run end of stop Use 11/32 in cable holding cable through wrench. Make sure screw (3) inner hole in stop control on stop lever and dashboard pushed tighten securing in and stop screw. lever on pump is all the way forward before tightening screw. i. Stop control Position and Use screwdriver. cable clamp secure with two (2) screws. j. Fuel line Install fuel Use 1/2 in open union nut (7) line between end wrench. pump and fuel If line does not filters. Con- appear to posi- nect and tighten tion properly union nut at when attempting pump end of installation line and at fuel check to see if filter end. it fits better by turning it around. NOTE Boat must be in water. Do fuel system bleed procedure per TM 5-1940-277-20. Start engine and check for leaks. Tighten any leaking connections. Proceed to next step with engine still running at idle speed. 2-257

Privacy Statement
Press Release
Contact