INJECTION PUMP REPLACEMENT INSTRUCTIONS (Continued)

INJECTION PUMP REPLACEMENT INSTRUCTIONS (Continued) - TM-5-1940-277-34_281

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
265

TM 5-1940-277-34 INJECTION PUMP REPLACEMENT INSTRUCTIONS (Continued) LOCATION ITEM ACTION REMARKS j. Idle speed Loosen lock nut Screw located adjusting and back screw on engine side screw (17) off. Set opera- of pump. Use tors throttle 1/2 in wrench and control so screwdriver. engine is idling at 650 rpm. Run screw up to con- tact with speed selector lever, hold and tighten lock nut. k. Maximum speed Loosen lock nut Screw located adjusting and back screw immediately below screw (18) off. Adjust idle adjusting operator throt- screw. Use 1/2 tie control for in wrench and 2800 rpm. Run screwdriver. screw up against speed selector lever, hold and tighten lock nut. NOTE Bring engine speed to idle for one minute and stop engine. Change 1 2-259 (2-260 Blank)

Privacy Statement
Press Release
Contact