INSPECTION, CLEANING AND REPAIR (cont)

INJECTOR TEST AND REPAIR INSTRUCTIONS (Continued) - TM-5-1940-277-34_292

INJECTOR TEST AND REPAIR INSTRUCTIONS (Continued) - TM-5-1940-277-34_294

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
276

TM 5-1940-277-34 INJECTOR TEST AND REPAIR INSTRUCTIONS (Continued) LOCATION ITEM ACTION REMARKS c. Replace nozzle and valve if blued or scoured. 5. Nozzle assembly a. Look at spray They should not (9) holes. be filled with carbon. b. If filled with carbon replace nozzle assembly. 6. Spring (6) a. Check for breaks, rust and square ends. b. Replace if defective. 7. Spindle (7) a. Examine sur- Should not be face in bore seriously at bottom end flattened. of spindle. b. Replace if damaged. 8. Nozzle holder a. Inspect joint (1) and nozzle faces for nut (8) scratches. b. Replace if scratched. 9. Nozzle assembly a. Wet all sur- (9) and needle faces with clean valve (10) diesel fuel. 2-271

Privacy Statement
Press Release
Contact