INSTALLATION (cont) - TM-5-1940-277-34

STEERING ASSEMBLY REPLACEMENT INSTRUCTIONS (Continued) - TM-5-1940-277-34_393

STEERING ASSEMBLY REPAIR INSTRUCTIONS - REVERSE BALANCE LEVER REPLACEMENT

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
377

TM 5-1940-277-34 STEERING ASSEMBLY REPLACEMENT INSTRUCTIONS (Continued) LOCATION ITEM ACTION REMARKS NOTE Perform step 17 if starboard steering assembly was removed and step 18 if port steering assembly was removed. Scoop control should be in full reverse. 17. Starboard hydro- Tie bar Fit tie bar to Use two 14 mm jet compartment securing nut inboard steering wrenches. (17) lever and install securing nut (17). 18. Port hydrojet Guide tube rod Seat end of Use 14 mm wrench compartment securing nut guide tube in and pinch bar to (18) hole on rotary pry tube guide control. Pry rod into posi- pivot end of rod tion. toward boat center until connection can be made to stud on inboard scoop control lever. Install nut when rod seated on stud. NOTE FOLLOW ON MAINTENANCE PROCEDURE: Do scoop and steering adjustment (TM 5-1940-277-20) Change 1 2-381 (2-382 Blank)

Privacy Statement
Press Release
Contact