TM 5-1940-277-34STEERING ASSEMBLY REPAIR INSTRUCTIONS - REVERSE BALANCE LEVER REPLACEMENT(Continued)LOCATIONITEMACTIONREMARKSREMOVALNOTEIf the reverse balance lever is broken the scoop will be secured in some manner or will be hangingfree. In either case movement of scoop will not occur when anything is disconnected. If the leveris not broken but only cracked the first step below will free scoop to drop to lowest point. Nodamage will occur but you should be prepared for this to happen.1.Ball jointNut (2), steelRemove larger ofUse 17 mm andpivot (1)washer (3) andtwo nuts and13 mm wrenches.tufnol washerwashers on eachThere are two(4)pivot and sepa-pivots, one eachrate pivot fromend of reversereverse balancebalance leverlever (13).(13). There will(Scoop controlbe a tufnolrod stayswasher (5) onattached topivot when itpivot.)separates. Donot lose it.NOTENext step is subject to equipment condition. If reverse balance lever is broken the reverse controlpivot will be attached only to outboard reverse balance lever. Before removing nut check for allcomponents [pivot (6), two flanged bushings (14), two steel washers (11, 8), two tufnol washers(10, 9), and nut (7)].2.Reverse controla.Nut (7),Remove.Use two 19 mmpivot (6)steel washerwrenches.(8) and tufnolwasher (9)2-385
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business