TM 5-1940-277-34
STEERING ASSEMBLY REPAIR INSTRUCTIONS - ROTARY CONTROL ASSEMBLY
(Continued)
LOCATION
ITEM
ACTION
REMARKS
c.
Front bearing
Fit into position
(11)
on front of cable
wheel (12).
d.
Seal sleeve
Fit into position
(10)
with bolt holes
alined with those
in cable wheel.
e.
Seal (9)
Fit into front
cover.
f.
Cover (7)
Carefully slide
Use screwdriver.
cover over seal
The cover posi-
sleeves and
tions the assem-
bearings. Move
bly components.
assembly into
Care should be
position and
taken to see that
secure cover
cover is properly
with four
positioned and
screws (8).
fitted.
g.
Crank (5) and
Fit crank over
cone (6)
cone and position
this subassembly,
alining bolt
holes in cone
with those in
seal sleeve (10).
h.
3 socket head
Install.
Tighten finger
screws (3)
tight.
with washers
(4)
i.
Ball joint
Fit pivot (14)
Use 17 mm wrench.
washer (2)
to crank (5) and
and nut (1)
install washer
and nut.
2-415
