DISASSEMBLE (cont) - TM-5-1940-277-34

ALTERNATOR REPAIR INSTRUCTIONS (Continued) - TM-5-1940-277-34_91

ALTERNATOR REPAIR INSTRUCTIONS (Continued) - TM-5-1940-277-34_93

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
75

TM 5-1940-277-34 ALTERNATOR REPAIR INSTRUCTIONS (Continued) LOCATION ITEM ACTION REMARKS i. 3 through Unscrew and Use flat tip screws (16) remove. screwdriver. and 3 lock- washers (17) j. Drive end a. Carefully Tap lightly with shield (18) withdraw from hammer to with rotor stator (20). separate. (19) CAUTION Do not damage slip rings when placing on table. b. Place over Cylinder support large dia- must be large meter enough to encase cylinder rotor and small support (21). enough to slip inside drive end shield (18) and support assembly with three end shield webs seated squarely onto cylinder. c. Screw nut This prevents (22) onto rotor from shaft. dropping onto slip rings during disassembly. d. Press rotor Use press (24). shaft (23) from drive end shield (18). e. Remove from cylinder support. 2-61

Privacy Statement
Press Release
Contact