TM 5-1940-322-24
0039 00
INSTRUMENT PANEL GAUGE AND BULB REPLACEMENT (Contd)
CAUTION
Ensure instrument panel is supported during removal and
installation. Failure to comply may result in damage to equipment.
NOTE
All gauges on the instrument panel are replaced the same way. This
procedure covers replacement of one gauge.
Tag all wires during removal to assist with installation.
INSTRUMENT PANEL GAUGE REMOVAL
CAUTION
Use caution when removing instrument panel from control console.
Failure to comply may result in damage to equipment.
1.
Remove six screws (11) and instrument panel (12) from control console (13).
2.
3.
Remove three nuts (4), three washers (5), and three lead wires (6) from terminals (10) on gauge (9).
4.
Remove two nuts (1), two washers (2), clamp (3), and gauge (9) from instrument panel (12).
BULB REMOVAL
1.
Remove bulb holder (7) from gauge (9) by turning counterclockwise.
2.
Remove bulb (8) from bulb holder (7).
BULB INSTALLATION
1.
Install bulb (8) in bulb holder (7).
2.
Install bulb holder (7) in gauge (9) by turning clockwise.
INSTRUMENT PANEL GAUGE INSTALLATION
1.
Install gauge (9) in instrument panel (12) with clamp (3), two washers (2), and two nuts (1).
2.
Install three lead wires (6) on terminals (10) of gauge (9) with three washers (5) and three nuts (4).
3.
4.
Install instrument panel (12) on control console (13) with six screws (11).
5.
6.
Close battery hatch (TM 5-1940-322-10).
0039 00-2