TM 5-1940-322-24
0046 00
BUS BARS AND JUNCTION BOX REPLACEMENT (Contd)
JUNCTION BOX INSTALLATION (Contd)
29.
If removed, install four new O-rings (30) on captive screws (31) and install screws (31) on junction box
cover (29).
30.
If removed, install new cover seal (32) on junction box cover (29) and install cover (29) on junction box
housing (3) and tighten four screws (31).
BUS BARS INSTALLATION
NOTE
The mounting hardware is the same for both bus bars. Only one
bus bar is shown removed from access panel.
1.
Install bus bar (14) on access panel (1) with two screws (20), washers (19), and new locknuts (9).
2.
Install electrical leads (17), (24), (25), and (26) on bus bar (14) with three new lockwashers (22) and
screws (23) as noted at removal.
3.
Install electrical leads (15) and (16) on stud (13) of bus bar (14) with new lockwasher (18) and nut (21)
as noted at removal.
4.
Install bus bar (8) on access panel (1) with two screws (20), washers (19), and new locknuts (9).
5.
Install electrical leads (10) and (11) on bus bar (8) with two new lockwashers (12) and screws (27) as
noted at removal.
6.
Install electrical leads (5) and (6) on stud (7) of bus bar (8) with new lockwasher (28) and nut (4) as
noted at removal.
7.
Close access panel (1) and install two wing nuts (2).
8.
Connect battery ground cables (WP 0054 00).
1
2
0046 00-12
