TM 5-1940-322-24
0058 00
INSPECTION LIGHT, BULB, AND BRACKET REPLACEMENT (Contd)
NOTE
Tag all lead wires during removal to assist with installation.
REMOVAL
1.
Disconnect plug (6) from receptacle (7).
2.
Remove inspection light (13) from post (5).
3.
Remove screw (14), clamp (11), and lamp (8) from inspection light (13) by folding lip of inspection light
back.
4.
Disconnect two electrical connectors (12) from inspection light (13).
5.
Remove two screws (10) and lead wires (9) from lamp (8).
6.
Remove locknut (16), two washers (15), and post (5) from bracket (3). Discard locknut (16).
7.
Remove three locknuts (4), six washers (2), and three screws (1) from bracket (3). Discard locknuts (4).
8.
Remove bracket (3) from boat (17).
INSTALLATION
1.
Secure bracket (3) on boat (17) with three screws (1), six washers (2), and three new locknuts (4).
2.
Install post (5) on bracket (3) with two washers (15) and new locknut (16).
3.
Install two lead wires (9) on lamp (8) with screws (10).
4.
Connect two electrical connectors (12) on inspection light (13).
5.
Install lamp (8) in inspection light (13) with clamp (11) and screw (14).
6.
Install inspection light (13) on post (5).
7.
Connect plug (6) to receptacle (7).
8.
Close battery hatch (TM 5-1940-322-10).
0058 00-2
