TM 5-1940-322-24
0063 00
MASTER LINK AND FUSE REPLACEMENT (Contd)
NOTE
Both master links are replaced the same way. This procedure covers
the replacement of the port side master link. Refer to wiring
schematic for starboard side configuration.
Tag all lead wires during removal to assist with installation.
REMOVAL
1. Remove tiedown straps (1) from cables (2). Discard tiedown straps (1).
2. Disconnect master link connector (13) from housing (8).
3. Remove two screws (12) and covers (14) from housing (8).
4. Loosen two screws (10) and remove cables (11) and caps (9) from housing (8).
5. Remove four locknuts (7) and washers (6) from studs (4). Discard locknuts (7).
6. Remove mounting plate (15) from hull (3).
7. Remove two locknuts (16) and screws (17) securing housing (8) on mounting plate (15). Discard
locknuts (16).
8. Remove two screws (18) and fuse (19) from master link fuse terminal (20).
INSTALLATION
1. Install fuse (19) on master link fuse terminal (20) with two screws (18).
2. Secure housing (8) on mounting plate (15) with two screws (17) and new locknuts (16).
3. Secure mounting plate (15) on studs (4) with four washers (6) and new locknuts (7).
4. Snap two caps (9) on housing (8).
CAUTION
Ensure enough bare wire is accessible on cable to allow screw to
make good connection with housing. Failure to comply may result
in damage to equipment.
5. Install two cables (11) on housing (8) and tighten screws (10).
6. Install two covers (14) on housing (8) with screws (12).
7. Connect master link connector (13) on housing (8).
8. Install new tiedown straps (1) on cables (2).
11. Close battery hatch (TM 5-1940-322-10).
0063 00-2