TM 5-1940-322-24
0098 00
STARTER RELAY MAGNETIC SWITCH MAINTENANCE (Contd)
NOTE
The starter relay magnetic switches on both engines are replaced
the same way. This procedure covers the replacement of one starter
relay magnetic switch.
Tag all electrical leads during removal to assist with installation.
REMOVAL
1. Remove two nuts (11) and lockwashers (10) from posts (5) and (15). Discard lockwashers (10).
2. Remove electrical leads (3) and (4) and cable (16) from posts (5) and (15).
3. Remove nut (9) and lockwasher (8) from post (6). Discard lockwasher (8).
4. Remove nut (9) from post (1).
5. Remove electrical leads (2) and (7) from posts (6) and (1).
6. Remove two nuts (17), bolts (12), and starter relay magnetic switch (13) from mounting bracket (14).
CLEANING AND INSPECTION
1. For general cleaning and inspection instructions, refer to WP 0013 00.
2. Clean cable (16) and electrical leads (2), (3), and (7) with parts cleaning brush. Replace cable or lead
wires if damaged.
INSTALLATION
1. Install starter relay magnetic switch (13) on mounting bracket (14) with two bolts (12) and nuts (18).
Tighten nuts to 32 lb-ft (43 Nm).
2. Install electrical lead (2) on post (1) with nut (9).
3. Install electrical lead (7) on post (6) with new lockwasher (8) and nut (9).
4. Install electrical leads (3), (4), and (16) on posts (5) and (15) with new lockwashers (10) and nuts (11).
5. Connect battery ground cables (WP 0054 00).
6. Close battery hatch (TM 5-1940-322-10).
7. Close engine hatches (TM 5-1940-322-10).
0098 00-2
