TM 5-1940-322-24
0099 00
STARTER MAINTENANCE (Contd)
NOTE
Tag all electrical leads during removal to assist with installation.
The starters on both engines are replaced the same way. This
procedure covers the replacement of one starter.
REMOVAL
1. Remove nuts (5) and (8), lockwashers (4) and (9), and electrical leads (3), (6), (7), and (11) from
posts (2) and (10). Discard lockwashers (4) and (9).
2. Remove three screws (13) securing starter (12) to bell housing (14). Remove starter (12).
CLEANING AND INSPECTION
1. For general cleaning and inspection instructions, refer to WP 0012 05.
2. Inspect electrical leads (3), (6), (7), and (11) for damage. Replace electrical leads if damaged.
3. Inspect electrical leads (3), (6), (7), and (11) for corrosion. Clean electrical leads with parts cleaning
brush if corroded.
INSTALLATION
1. Secure starter (12) on bell housing (14) with screws (13). Tighten screws to 32 lb-ft (43 Nm).
2. Connect electrical leads (3), (6), (7), and (11) with two new lockwashers (4) and (9) and nuts (5) and (8)
to posts (2) and (10).
3. Connect battery ground cables (WP 0054 00).
4. Close battery hatch (TM 5-1940-322-10).
5. Close engine hatches (TM 5-1940-322-10).
0099 00-2
