TM 5-1940-322-24
0101 00
CYLINDER HEAD MAINTENANCE (Contd)
NOTE
The cylinder heads on both engines are replaced the same way. This
procedure covers the replacement of one cylinder head.
Assistant will help with removal and installation.
REMOVAL
NOTE
There are three different lengths of cylinder head bolts. Note the
position of each bolt for installation.
1.
Remove twenty bolts (1), cylinder head (2), and gasket (3) from cylinder block (4). Discard gasket (3).
2.
Remove dowels (5) from cylinder block (4).
CLEANING AND INSPECTION
1.
For general cleaning and inspection instructions, refer to WP 0013 00.
WARNING
Skysol 100 solvent is combustible; DO NOT use or store near heat,
sparks, flame, or other ignition sources. Use mechanical ventilation
whenever product is used in a confined space, heated above
ambient temperatures, or agitated. Keep container sealed when not
in use.
Contact with Skysol 100 may cause skin irritation. Use chemical-
resistant gloves. In case of skin contact, remove any contaminated
clothing and wash skin thoroughly with soap and water. Wash
contaminated clothing before reuse. Eye contact may cause
irritation, tearing, or blurring of vision. Use face shield or goggles
when eye contact may occur. In case of eye contact, flush eyes with
large amounts of water for at least 15 minutes or until irritation
subsides. Inhalation may cause irritation to upper respiratory
passages. DO NOT have food or drink in the vicinity. Failure to
comply may result in injury to personnel.
2.
Clean excess gasket material from cylinder head (2) and cylinder block (4) mating surfaces with
Skysol 100 and dry with cloth.
0101 00-2