TM 5-1940-322-24
0150 00
ANODES MAINTENANCE (Contd)
HYDROJET ANODE REMOVAL
NOTE
Anodes should be replaced when 50% of original volume is missing.
1.
Position and support scoop reverse deflectors in raised position (TM 5-1940-322-10).
2.
Remove locknut (2), washer (3), and anode (4), from hydrojet tail shaft (1). Discard locknut (2).
3.
Remove locknut (8), washer (7), anode (6), and fiber washer (5) from hydrojet drive (15). Discard fiber
washer (5) and locknut (8).
4.
Remove locknut (10), washer (11), anode (12), wire lead (9), and spacer (14) from hydrojet drive (15).
Discard locknut (10).
5.
Remove locknut (10), washer (11), anode (12), wire lead (9), and fiber washer (13) from hydrojet
drive (15). Discard fiber washer (13) and locknut (10).
6.
Repeat steps 1 through 5 for other hydrojet anodes.
SCOOP REVERSE DEFLECTOR ANODE REMOVAL
1.
Remove two locknuts (29), washers (28), anode (25), and two fiber washers (27) from hydrojet scoop
reverse deflector (26). Discard fiber washers (27) and locknuts (29).
2.
Perform step 1 for remaining scoop reverse deflector anode.
HULL ANODE REMOVAL
Remove two locknuts (23), washers (21), anodes (22), and screws (20) from hull keel (24). Discard
locknuts (23).
KEEL COOLER ANODE REMOVAL
1.
Remove keel cooler grates (WP 0067 00).
2.
Remove four screws (19), lockwashers (18), and anodes (17) from keel cooler (16). Discard
lockwashers (18).
3.
Perform steps 1 and 2 for remaining keel cooler anodes.
0150 00-2
