TM 5-1940-322-24
0159 00
FLYWHEEL RING GEAR MAINTENANCE (Contd)
NOTE
Both flywheel ring gears are replaced the same way. This procedure
covers the replacement of one flywheel ring gear.
REMOVAL
CAUTION
Do not use a steel drift pin. Failure to comply may result in damage
to ring gear and/or flywheel.
Using brass drift pin, remove flywheel ring gear (1) from flywheel (2).
INSTALLATION
1.
Heat new ring gear (1) for 20 minutes in oven preheated to 127 C (260 F).
WARNING
To reduce the possibility of severe burns, wear protective gloves
when installing the heated gear. Failure to comply may result in
injury to personnel.
CAUTION
The ring gear must be installed so the bevel on the teeth is toward
the crankshaft side of the flywheel. Failure to comply may result in
damage to equipment.
NOTE
If experiencing difficulty installing flywheel ring gear on flywheel,
use a brass drift pin to assist with installation.
2.
Install flywheel ring gear (1) on flywheel (2).
3.
Install flywheel (WP 0157 00).
4.
Install transmission driveplate (WP 0121 00).
5.
Install transmission adapter plate (WP 0122 00)
6.
Install transmission (WP 0125 00).
7.
Close engine hatches (TM 5-1940-322-10).
0159 00-2
