TM 5-5420-202-20-2
FUEL TANK BUTTERFLY VALVE REPLACEMENT (Sheet 4 of 7)
D r y cleaning solvent P-D-680 is toxic and flammable.
T o prevent personal injury, wear
protective goggles and gloves and use only in a well-ventilated area. Avoid contact with skin,
eyes, and clothes and don't breathe vapors. Do not use near open flame or excessive heat. The
flash point for Type #1 Dry Cleaning Solvent is 100F (38C) and for Type #2 is 138F (50C).
If you become dizzy while using cleaning solvent, get fresh air immediately and get medical aid.
If contact with eyes is made, wash your eyes with water and get medical aid immediately.
10. Using dry cleaning solvent, cloth and putty knife, clean excess material from fuel tank.
NOTE
The following steps of valve installation will be performed in
engine compartment.
INSTALLATION:
1.
Install new gasket (A), butterfly valve (B), and preformed hose (C) to right fuel tank (D)
using five screws (E) and washers (F).
2.
Install preformed hose (C) to left fuel tank (G) using five screws (H) and washers (J).
3.
Using 1/2 inch wrench, loosely install five screws (E) and five screws (H).
Go on to Sheet 5
