TM
5-5420-202-20-2
ACCELERATOR CONTROL ROD REPLACEMENT (Sheet 2 of 5)
2.
Using retaining ring pliers, remove two
retaining rings (B) from grooves (C)
in control rod (D).
Remove housing (E) from control
3.
rod (D).
Using 7/16 inch socket, remove three
4.
screws (F) and lockwashers (G).
Using 9/16 inch socket, remove two
5.
screws (H), lockwashers (J), flat washers
(K), and shim (L) (if so equipped).
Remove housing (M) from control rod (D).
6.
Using hammer and drive punch, remove
7.
bushings (N) from housings (E) and (M).
Using hammer and drive punch, tap
8.
control rod (D) out of link (P) and
pedal (Q).
Go on to Sheet 3
7-309