TM 5-5420-202-20-2
TM 5-5420-202-34
FUEL TANK (LEFT) LOWER FRONT MOUNT REPLACEMENT (Sheet 3 of 4)
CLEANING AND INSPECTION:
1.
Clean rubber mounts using detergent and water. Rinse clean using water.
Dry cleaning solvent P-D-680 is toxic and flammable. To prevent
personal injury, wear protective goggles and gloves and use only in a
well-ventilated area. Avoid contact with skin, eyes, and clothes and
don't breathe vapors. Do not use near open flame or excessive heat.
The flash point for Type #1 Dry Cleaning Solvent is 100F (38C) and
for Type #2 is 138F (50C). If you become dizzy while using cleaning
solvent, get fresh air immediately and get medical aid. If contact
with eyes is made, wash your eyes with water and get medical aid
immediately.
2.
Clean metal parts with dry cleaning solvent. Wipe dry with rags.
Visually inspect rubber mounts for cuts, deterioration, or wear.
3.
4.
Visually inspect metal parts for wear.
5.
Replace unserviceable parts.
INSTALLATION:
1.
Install rubber mounts (A), and washers (B) to bracket (C) using screw (D), washer (E),
nut (F) and new lockwasher (G).
Go on to Sheet 4
Change 5
74-83
-361