TM 5-5420-202-20-3
CLEANING AND INSPECTION:
WARNING
To prevent personal injury, wear
Dry cleaning solvent P-D-680 is toxic and flammable.
protective goggles and gloves and use only in a well-ventilated area. Avoid contact with skin,
eyes, and clothes and don't breathe vapors. Do not use near open flame or excessive heat. The
flash point for Type #1 Dry Cleaning Solvent is 100F (38C) and for Type #2 is 138F (50C).
If you become dizzy while using cleaning solvent, get fresh air immediately and get medical aid.
If contact with eyes is made, wash your eyes with water and get medical aid immediately.
Using alcohol and rags, clean
1.
hose. Inspect for cracks and
breaks. If hose is damaged,
replace hose.
2. Using dry cleaning solvent, clean all removed parts.
Using rags, wipe all removed parts dry.
3.
Inspect mounting hardware and pipe for damage. Replace parts as required, if defective or
4.
missing.
INSTALLATION:
NOTE
Apply silicone compound to the inside of the generator boot sealing surfaces
before installation.
1. Position pipe (A) through engine shroud.
Assemble clamp (B) to pipe (A).
2.
3. Using 1/2-inch socket, install two
screws (C), lockwashers (D), and
clamp (B) to pipe (A).
TA248957
Go on to Sheet 4
10-16