TM 5-5420-202-2 -3
BRAK E PEDAL ADJ U ST M EN T (She e t 2 of 2 )
2.
Using two 11/16 inch wrenches loosen jam nuts (C) and (D), using 5/8 inch wrench adjust
tie rod (E) for a reading of 175 to 250 psi on pressure gage (F). Tighten jamnuts (C) and (D).
3.
Remove locating pin installed in step 1.
4.
Depress brake pedal until brake pedal cam face just contacts roller surface (G).
5.
Check pressure gage (F) for 0 psi reading.
6. Using 9/16 inch wrench, loosen jamnut (H).
7.
Using 3/8 inch wrench, adjust screw (J) until screw (J) just makes contact with brake
lever (K). Tighten jamnut (H).
Set transmission shift lever to "P" park position (TM 5-5420-202-10).
8.
Remove blocks from vehicle tracks (TM 5-5420-202-10).
9.
T A2 4 9 4 0 8
End of Task
13-18
