TM 5-5420-202-20-3
HYDRAULIC BRAKE SYSTEM BLEEDING (Sheet 2 of 4)
Connect the filler and bleeder hydraulic system (B) to filler cap (A) hole.
4.
NOTE
Filler and bleeder hydraulic system
will maintain pressure and fill master
cylinder with fluid.
5.
Using 3/8 inch wrench, open bleeder valve (C) on master cylinder (D). Let hydraulic
fluid run until no air bubbles are detected in hydraulic fluid. Close bleeder valve (C).
Using 9/16 inch wrench on nut (E) and 3/4 inch wrench on elbow (F), loosen nut (E) and
6.
bleed gage (G) until no air bubbles are observed in hydraulic fluid. Tighten nut (E) holding
elbow (F).
Go on to Sheet 3
TA249471
13-87